How To Program Acura RL Remote

AT TIME OF PROGRAMMING, ALL REMOTES (UP TO 3) TO BE PROGRAMED/REPROGRAMMED MUST BE PRESENT.

The following steps 1-12 are done on a single remote, step 13 is done on all remotes to beprogrammed. (Up to 3 can be programmed)

1) Get into the car shut the doors and make sure they are unlocked

2) Turn on the ignition (do not turn on the car just the ignition

3) Press the lock button on remote

4) Turn key to the accessory ON position (your radio works in this mode

5) Turn on the ignition (do not turn on the car just the ignition

6) Press the lock button on remote

7) Turn key to the accessory ON position (your radio works in this mode

8) Turn on the ignition (do not turn on the car just the ignition

9) Press the lock button on remote

10) Turn key to the accessory ON position (your radio works in this mode

11) Turn on the ignition (do not turn on the car just the ignition)

12) Press the lock button on the remote, the locks should chirp to indicate that programming mode was entered successfully

13) Press the LOCK button on remote, the doors should chirp again to confirm programming. PRESS THE LOCK BUTTION ON EACH OF THE REMAINING REMOTES TO BE PROGRAMMED (ONE AT A TIME)


14) Turn off the car fully and try locking/unlocking with remote

Below step is optional:

To turn on/off the chirping when locking/unlocking with remote do the following:

1) Press the trunk release button on the remote and hold it


2) While holding, press the LOCK button on remote and hold it, the led on the remote will flicker for about 1sec


3) After the LED goes off, release both buttons and test it

4) The procedure for chirp on and chirp off is the same, this needs to be done on all remotes otherwise only the one programmed will allow chirping while the others will still be silent or vise versa.