How To Program Honda Remote

Difficulty: Easy
Instructions
Things You'll Need:
A Honda vehicle with keyless entry
a key to the vehicle
ALL keyless remotes to be programmed for the vehicle (you have to program them all together) a non-programmed remote will work for this process

Step 1
Unlock the doors.

Step 2
Turn key to position II.
Turn the ignition key to the "ON" (II) position. (This is the position where the key sits while you're driving. The accessories should come on and the dashboard will light-up.)

Step 3
Your remote may look slightly different.
Press the "LOCK" or "UNLOCK" button on the remote control transmitter.

Step 4
Turn key to position 0 or I. (Shown in position 0)
Turn the ignition key to the "OFF" (0 or I) position.

Step 5
Turn key to position II.
Turn the ignition key to the "ON" (II) position.

Step 6
Your remote may look slightly different.
Press the "LOCK" or "UNLOCK" button on the remote control transmitter.

Step 7
Turn key to position 0 or I. (Shown in position 0)
Turn the ignition key to the "OFF" (0 or I) position.

Step 8
Turn key to position II.
Turn the ignition key to the "ON" (II) position.

Step 9
Your remote may look slightly different.
Press the "LOCK" or "UNLOCK" button on the remote control transmitter.

Step 10
Turn key to position 0 or I. (Shown in position 0)
Turn the ignition key to the "OFF" (0 or I) position.

Step 11
Turn key to position II.
Turn the ignition key to the "ON" (II) position.

Step 12
Your remote may look slightly different.
Press the "LOCK" or "UNLOCK" button on the remote control transmitter.• The power door locks cycle to indicate programming mode.• To terminate the programming mode at this point, either turn the ignition key to the "OFF" position or leave the remote’s button untouched for over 10 seconds.• To program, continue to step 13.

Step 13
Press the "LOCK" button of each remote (one at a time) to be stored in memory. Remember to program ALL remotes during this step.
Press the "LOCK" button of each remote (one at a time) to be stored in memory.• The power door locks cycle to confirm each entry.• A button on EACH remote control transmitter to be programmed MUST bepressed. Perform this programming step within 10 seconds for each remote or else the programming mode will terminate and some remotes may not be programmed.Note: Only 3 remotes can be stored in the system’s memory.

Step 14
Turn key to position 0 and