Tuesday, June 9, 2009

How to program Mitsubishi Remote

Mitsubishi keyless remote programming instructions:Programming:(Note: Entering new remote transmitter codes will erase all old codes. All remote transmitters must be programmed together.)-Ensure ignition switched OFF.-Access data link connector (DLC) located behind fascia.-Jump DLC terminal 1 and ground. ( should be done with diagnostic equipment).(Note: Terminal 1 may also be grounded using diagnostic equipment connected to the DLC.)-Within 10 seconds: Press hazard switch six times.-Doors should lock and unlock to confirm registration mode.-Press and release remote transmitter LOCK button.-Within 10 seconds: Press remote transmitter LOCK button twice.-Doors should lock and unlock to confirm registration.-If registering additional remote transmitters, within 1 minute: Repeat button procedure for each remote transmitter.-Doors should lock and unlock to confirm registration.Note: To exit programming mode: Remove key from ignition or remove jump lead.Note: A maximum of 4 remote transmitters can be programmed.

No comments:

Post a Comment